Click to Join the Discord and Receive a 35% Discount
Have some thicker plates that need a hot sync? No worries! EZ-PZ!
First of all, what is a sync?
The atomizer sync function is designed to prevent you from burning or over heating heat plates as well as a diagnostic tool to help you understand your atomizer health. Pressing the power and minus button one time when you have attached a new atomizer or a cleaned atomizer is needed but that is all.
How do I sync?
For V1 and V2 (any black Versa base) you will press and hold Power (o) and Minus (-) at the same time on the device.
For V2.5 (any white or Audrey blue base) TURN OFF THE VERSA BASE BY CLICKING 3 TIMES. Then press and hold Power (o) and Minus (-) at the same time on the device.
If you try to sync while the device is on for V2.5 you will reset your dab counter.
You will see a 3 digit number on the screen, that is your sync.
You will sync every time you clean the atomizer or remove it and replace it from the base. (V2.5 will sync automatically, but if you have upgraded heat plates or prefer a hot sync it will need to be done manually anytime the atomizer is removed from the base).
Show me how to hot sync!
Hot sync is recommended for RBA users or anyone with thick plates.
For users with 1.0mm or 1.3mm heat plates, you may want to hot sync to increase vapor production.
You want to try to sync as close to 700mr as possible, but anywhere from 650mr+ should be functional. To do this you'll need to sync when the display temp is between 300-400F during cooldown. You only need to do this when you remove the atomizer and put it (or another) back in, not after every use.
To hot sync:
To sync the thick plates, you must do it while the device is hot. This will solve your issue.
1. Turn on device, leave empty.
2. Set to 300-350F and fire up. Let get to full temperature and turn off
3. Count to 3 and turn back on. Sync immediately.
Goal is to have a sync in the range of 600-700
Please reach out to customer support on the website if you need assistance troubleshooting.
A Detailed breakdown of the RBA Versa Diffuser, Fully rebuildable diffuser with upgraded airflow! Get yours today!
Titanium Crucible Titan: Start out with a low temp. 440F Medium Speed, 30 Second Sesh. From there you can move up if needed but we recommend staying below 465F for flavor. Magnum: Start at 440F (potentially as low as 430F with a low Sync) 30 Second run time. You can bump up to a 60 second run time if you have enough loaded. Otherwise stick to the 30 second Sesh for titanium. Flavor Rating: 3.7 / 5.0 ----------------------------------------------------------------- Quartz Crucible Titan: Start out with a Medium temp around 470F, no higher then 500F for 60 seconds. Magnum: 470F starting temp Medium for 60 seconds. Go up or down as needed but no higher then 500F Flavor Rating: 4.0 / 5.0...
In the spirit of transparency (we find it not only beneficial to you, our customers, but also to the Source V brand as well) the information we are able to gather, from the general consensus, helps us in fine-tuning the improvements needed to ensure we put out the best product possible. That being said, we are going to be open about the % of failure rates with the diffusers. We will also discuss, the Pros and Cons of each atomizer we are expecting to release. When it comes to the Versa Diffuser, it is our goal to continue to have a multitude of options available for the consumer. With that, we have already been working on the next generations of...